Configuring Traffic Accounting - H3C S7500 Series Operation Manual

Operation Manual – Traffic Accounting
H3C S7500 Series Ethernet Switches
Note:
This document describes the configuration of traffic accounting. The configuration of
802.1x and CAMS server is not covered here.

1.2.2 Configuring Traffic Accounting

The following table describes the configuration tasks for traffic accounting.
Table 1-1 Configure the traffic accounting function
To do...
Enter system view
Configure the traffic
accounting slot
Specify a traffic
collection card
Enable the traffic
accounting function
Table 1-2 Configure traffic group
Configuration
Enter system view
Configure a traffic group
Configure a network
address for the traffic
group
Use the command...
system-view
traffic-accounting
accounting-slot
slot-num
traffic-slot slot-num
accounting enable
Use the command...
system-view
traffic-accounting
traffic-group
group-name
network ip-address
{ mask | mask-len }
1-3
Chapter 1 Traffic Accounting Configuration
Remarks
—
Required
The specified
accounting slot must be the
slot where
accounting card resides.
You will
accounting view directly after
the configuration succeeds.
By default,
accounting slot is specified.
Required
Required
By default, this function is
disabled on the traffic accounting
card.
Remarks
—
Required
Enter traffic group view
automatically after
successful configuration.
Required
Use this command in
traffic group view.
traffic
the traffic
enter traffic
no traffic