Configuring Default-Route Telnet Protection - H3C S7500 Series Operation Manual

Operation Manual – Telnet Protection
H3C S7500 Series Ethernet Switches
To do...
Enter system view
Enable ICMP
protection
Enable global Telnet
protection or special
ARP Telnet
protection

1.2.4 Configuring Default-route Telnet Protection

Follow these steps to configure default-route Telnet protection:
Enter system view
Enable default-route
Telnet protection
Use the command...
system-view
attack-protection
icmp [ ip-address ]
attack-protection
[ ip-address ]
To do...
system-view
undo attack-protection
disable-defaultroute
Chapter 1 Telnet Protection Configuration
—
Required
If you use this command with the
ip-address parameter, you can
protect the packets that match
this source IP address only.
Required
If you use this command with the
ip-address parameter, you can
protect the specified Layer-3
interfaces.
Use the command...
1-3
Remarks
Remarks
—
Required
By default, default-route
Telnet protection is
disabled.