Loading Software Using Tftp Through Ethernet Port - H3C S7500 Series Operation Manual

Hide thumbs Also See for S7500 Series:

Table of Contents

Operation Manual – System Maintenance and Debugging

H3C S7500 Series Ethernet Switches

Bootrom updating.....................................done!

If the HyperTerminal's baud rate is not reset to 9600 bps, the system prompts "Your

baudrate should be set to 9600 bps again! Press enter key when ready".

You need not reset the HyperTerminal's baud rate and can skip the last step if you

have chosen 9600 bps. In this case, the system upgrades Boot ROM automatically

and prompts "Bootrom updating now.....................................done!".

III. Loading host software

Follow these steps to load the host software:

Step 1: Select <1> in Boot Menu and press <Enter>. The system displays the following

information:

1. Set TFTP protocol parameter

2. Set FTP protocol parameter

3. Set XMODEM protocol parameter

0. Return to boot menu

Enter your choice(0-3):

Step 2: Enter 3 in the above menu to download the host software using XMODEM.

The subsequent steps are the same as those for loading the Boot ROM software,

except that the system gives the prompt for host software loading instead of Boot ROM

1.2.3 Loading Software Using TFTP through Ethernet Port

I. Introduction to TFTP

TFTP, one protocol in TCP/IP protocol suite, is used for trivial file transfer between

client and server. It uses UDP to provide unreliable data stream transfer service.

II. Loading Boot ROM software

Figure 1-6 Local loading using TFTP

Console port

Chapter 1 Boot ROM and Host Software

Table of Contents