H3C S7500 Series Operation Manual page 913

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Debugging information Debugging information
Protocol debugging switches Protocol debugging switches
Terminal display switches Terminal display switches
Figure 2-1 Debugging information outpu
You can use the following commands to operate the two kinds of switches.
Perform the following operations in user view.
Follow these steps to enable debugging and terminal display:
To do...
Enable system
debugging
Enable terminal
display for
debugging
ON ON OFF OFF
OFF OFF
t
Use the command...
debugging { all
[ timeout interval ] |
module-name
debugging-option }
terminal debugging
2-5
Chapter 2 Basic System Configuration and
ON ON
ON ON
Remarks
By default, all debugging is disabled in
the system.
Because the output of debugging
information will affect the efficiency of the
system, disable your debugging after
you finish it.
By default, terminal display for
debugging is disabled.
Debugging