Information Center Configuration Examples; Log Output To A Unix Log Host - H3C S7500 Series Operation Manual

Hide thumbs Also See for S7500 Series:

Table of Contents

Operation Manual – Information Center

H3C S7500 Series Ethernet Switches

Clear information recorded in log

Clear information recorded in trap

1.4 Information Center Configuration Examples

I. Network requirements

The switch sends the following log information in English to the Unix log host whose IP

address is 202.38.1.10: the log information of the two modules ARP and IP, with a

severity higher than "informational".

II. Network diagram

Figure 1-1 Network diagram for log output to a Unix log hos

III. Configuration procedure

Configure the switch:

# Enable the information center.

<H3C> system-view

[H3C] info-center enable

# Disable for all modules the function of outputting information to log host channels.

[H3C] undo info-center source default channel loghost

# Configure the host whose IP address is 202.38.1.10 as the log host. Set the output

language to English. Permit ARP and IP modules to output information with a severity

higher than "informational" to the log host.

[H3C] info-center loghost 202.38.1.10 facility local4 language english

[H3C] info-center source arp channel loghost log level informational debug

state off trap state off

[H3C] info-center source ip channel loghost log level informational debug state

off trap state off

Configure the log host:

Chapter 1 Information Center

Use the command...

reset logbuffer

reset trapbuffer

Table of Contents