Operation Manual – SNMP and RMON
H3C S7500 Series Ethernet Switches
Table 1-1 Common MIBs
MIB attribute
Public MIB
Private MIB
1.2 Configuring SNMP Basic Functions
The configuration of SNMPv3 is different from that of SNMPv1 and SNMPv2c, so
SNMP basic function configurations for different versions are introduced respectively.
For specific configurations, refer to the following two tables.
Follow these steps to configure SNMP basic functions for SNMPv1 and SNMPv2c:
Enter system view
Enable SNMP agent
MIB content
MIB II based on TCP/IP network
devices
BRIDGE MIB
RIP MIB
RMON MIB
Ethernet MIB
OSPF MIB
IF MIB
DHCP MIB
QACL MIB
ADBM MIB
RSTP MIB
VLAN MIB
Device management
Interface management
To do...
Use the command...
system-view
snmp-agent
1-3
Chapter 1 SNMP Configuration
References
RFC1213
RFC1493
RFC2675
RFC1724
RFC2819
RFC2665
RFC1253
RFC1573
—
—
—
—
—
—
—
Remarks
—
Optional
By default, SNMP
agent is disabled
To enable SNMP
agent, you can
execute this
command or those
commands used to
configure SNMP
agent features