H3C S7500 Series Operation Manual page 265

Operation Manual – MSTP
H3C S7500 Series Ethernet Switches
[H3C-Ethernet2/0/1] stp edged-port enable
1.2.12 Point-to-point Link-Related Configuration
A point-to-point link directly connects two switches. If the roles of the two ports at the
two ends of a point-to-point link meet certain criteria, the two ports can transit to the
forwarding state rapidly by exchanging synchronization packets, eliminating the
forwarding delay.
You can specify whether or not the link connected to a port is a point-to-point link in one
of the following two ways.
I. Configuration procedure (in system view)
Follow these steps to specify whether or not the links connected to the specified ports
are point-to-point links (in system view):
To do ...
Enter system
view
Specify
whether or
not the links
connected to
the specified
ports are
point-to-point
links
II. Configuration procedure (in Ethernet port view)
Follow these steps to specify whether or not the link connected to a specific port is a
point-to-point link (in Ethernet port view):
To do ...
Enter system view
Enter Ethernet port
view
Use the
command ...
system-view
stp interface
interface-list
point-to-point
{ force-true |
force-false | auto }
Use the command ...
system-view
interface interface-type
interface-number
1-21
Chapter 1 MSTP Configuration
Remarks
—
Required
The auto keyword is adopted by default.
The force-true keyword specifies that the
links connected to the specified ports are
point-to-point links.
The force-false keyword specifies that the
links connected to the specified ports are not
point-to-point links.
The auto keyword specifies to automatically
determine whether or not the links connected
to the specified ports are point-to-point links.
—
—
Remarks