Configuring Guest Vlan; Displaying And Debugging 802.1X - H3C S7500 Series Operation Manual

Operation Manual – 802.1x
H3C S7500 Series Ethernet Switches
Table 1-5 Enable DHCP-triggered authentication
Enter system view
Enable DHCP-triggered
authentication

1.5.5 Configuring Guest VLAN

Table 1-6 Configure Guest VLAN
Enter system view
Configure control access
method
Enable the Guest VLAN
function
Caution:
The Guest VLAN function is available only when the switch operates in a port-based
authentication mode.
Only one Guest VLAN can be configured for each switch.

1.6 Displaying and Debugging 802.1x

After performing the above configurations, you can display and verify the
802.1x-related configuration by executing the display command in any view.
You can clear 802.1x-related statistics by executing the reset command in user view.
To do...
system-view
dot1x dhcp-launch
To do...
system-view
dot1x port-method
{ macbased |
portbased }
dot1x guest-vlan vlan-id
[ interface interface-list ]
Use the command...
Use the command...
1-18
Chapter 1 802.1x Configuration
Remarks
—
Disabled by default
Remarks
—
Optional
macbased method by
default
Required
Disabled by default