Leaf Node Configuration - H3C S7500 Series Operation Manual

Operation Manual – MSTP
H3C S7500 Series Ethernet Switches
2) Configure in Ethernet port view.
<H3C> system-view
[H3C] stp enable
[H3C] interface ethernet2/0/1
[H3C-Ethernet2/0/1] stp disable

1.3 Leaf Node Configuration

Complete the following tasks to configure leaf node:
MSTP Configuration
MST Region Configuration
MSTP Operation Mode Configuration
Timeout Time Factor Configuration
Maximum Transmitting Speed
Configuration
Edge Port Configuration
Path Cost Configuration
Port Priority Configuration
Point-to-point Link-Related
Configuration
Note:
In a network that contains switches with both GVRP and MSTP employed, GVRP
packets are forwarded along the CIST. If you want to broadcast packets of a specific
VLAN through GVRP, be sure to map the VLAN to the CIST when configuring the
MSTP VLAN mapping table (the CIST of a network is the MSTI numbered 0.)
1.3.1 Configuration Prerequisites
The status of the switches in the spanning trees is determined. That is, the status (root,
branch, or leaf) of each switch in each MSTI is determined.
Task
1-24
Chapter 1 MSTP Configuration
Remarks
Required
To prevent network topology jitter
caused by other related configurations,
you are recommended to enable MSTP
after performing other configurations.
Required
Optional
Optional
Optional
The default value is recommended.
Optional
Optional
Optional
Optional