H3C S7500 Series Operation Manual page 951

Operation Mannual – RRPP
H3C S7500 Series Ethernet Switches
Enable the primary ring
Enable the subring
Return to system view
Enable RRPP
Display the brief
information of all RRPP
domains configured on
the switch
Display RRPP
configuration details on
the switch
Display the RRPP packet
statistics on the switch
To clear the RRPP statistics, use the reset rrpp statistics domain domain-id [ ring
ring-id ] command.
Caution:
The control VLAN of an RRPP domain cannot be a static VLAN already created on
the switch. If you configure a dynamic VLAN as the control VLAN of an RRPP
domain, the VLAN becomes a static VLAN automatically.
You are not recommended to configure a VLAN as both an RRPP control VLAN and
a remote-probe VLAN. (Refer to Mirroring part of this manual for information about
remote-probe VLAN.)
You are not recommended to configure a VLAN as both an RRPP control VLAN and
an isolate-user-VLAN/sub VLAN. (Refer to Extended VLAN Application part of this
manual for information about isolate-user-VLAN and sub VLAN.)
Before creating an RRPP ring, you need to create the control VLAN.
When deleting an RRPP domain by using the undo rrpp domain command, make
sure no RRPP ring exists in the RRPP domain.
The ring IDs of different rings in the same RRPP domain cannot be the same.
To do...
ring ring-id enable
ring ring-id enable
quit
rrpp enable
display rrpp brief
display rrpp verbose
domain domain-id [ ring
ring-id ]
display rrpp statistics
domain domain-id [ ring
ring-id ]
Use the command...
1-15
Chapter 1 RRPP Configuration
Remarks
Required
Required
—
Required
Optional.
You can execute the
display command in any
view