H3C S7500 Series Operation Manual page 740

Operation Manual – Mirroring
H3C S7500 Series Ethernet Switches
Configure the remote
reflector port
Configure the
remote-probe VLAN of
the remote source
mirroring group
Ether Ethernet port view
of the source port
Enter QoS view
Reference ACLs for
identifying traffic flows
and perform traffic
mirroring for packets that
match.
Display configuration of
the remote source
mirroring group
Display the parameter
settings of traffic
mirroring
Display all QoS settings
of a port
acl-rule: Applied ACL rules, which can be the combination of different types of ACL
rules. For the ACL combinations of the type A LPUs, refer to
combinations of LPUs other than type A, refer to
To do... Use the command...
mirroring-group
group-id reflector-port
reflector-port
mirroring-group
group-id remote-probe
vlan
remote-probe-vlan-id
interface interface-type
interface-number
qos
mirrored-to inbound
acl-rule [ system-index ]
{ interface interface-type
interface-number
reflector |
mirroring-group
group-id }
display mirroring-group
remote-source
display qos-interface
[ interface-type
interface-number ]
mirrored-to
display qos-interface
[ interface-type
interface-number ] all
Chapter 1 Mirroring Configuration
Table 1-4.
1-17
Remarks
Required
The remote reflector port
must be Access port and
LACP and STP must be
disabled on the remote
reflector port.
After a port is configured as
reflector port, you can
neither change the port
type and the default VLAN
ID nor add the reflector port
to other VLANs.
Required
—
—
Required
Optional
You can execute the
display command in any
view.
Table 1-3, and for the ACL