Edge Node Configuration; Edge Node Configuration Tasks - H3C S7500 Series Operation Manual

Operation Mannual – RRPP
H3C S7500 Series Ethernet Switches
II. Configuration procedure
<H3C> system-view
[H3C] rrpp domain 1
[H3C-rrpp-domain1] control-vlan 4092
[H3C-rrpp-domain1] ring 1 node-mode transit primary-port GigabitEthernet2/0/1
secondary-port GigabitEthernet2/0/2 level 0
[H3C-rrpp-domain1] ring 1 enable
[H3C-rrpp-domain1] quit
[H3C] rrpp enable
[H3C] display rrpp brief
[H3C] display rrpp verbose domain 1
[H3C] display rrpp statistics domain 1

1.4 Edge Node Configuration

1.4.1 Edge Node Configuration Tasks

Follow these steps to configure an edge node:
Enter system view
Create an RRPP domain,
and enter RRPP domain
view
Specify a control VLAN
for the RRPP domain
Specify the current
switch as a transit node
of the primary ring, and
specify the primary port
and the secondary port
Specify the current
switch as an edge node
of the subring, and
specify a common port
and an edge port
Enable the primary ring
Enable the subring
Return to system view
Enable RRPP
To do... Use the command...
system-view
rrpp domain domain-id
control-vlan vlan-id
ring ring-id node-mode
transit [ primary-port
pri-port ]
[ secondary-port
sec-port ] level
level-value
ring ring-id node-mode
edge [ common-port
comm-port ] [ edge-port
edge-port ]
ring ring-id enable
ring ring-id enable
quit
rrpp enable
1-12
Chapter 1 RRPP Configuration
Remarks
—
Required.
The command prompt of
RRPP domain view
depends on the domain-id
you input.
Required
Required.
Level 0 identifies the primary
ring and level 1 identifies a
subring.
Required
Required
Required
—
Required