H3C S7500 Series Operation Manual page 228

Operation Manual – DLDP
H3C S7500 Series Ethernet Switches
Set the DLDP handling mode
when an unidirectional link is
detected
Set the operating mode of DLDP
Enter Ethernet port view
Force the duplex attribute
Force the speed value
Display the configuration
information about the
DLDP-enabled ports
To do...
1-11
Chapter 1 DLDP Configuration
Use the command...
dldp
unidirectional-shutdown
{ auto | manual }
dldp work-mode { enhance
| normal }
interface interface-type
interface-number
duplex full
speed speed-value
display dldp [ interface-type
interface-number ]
Remarks
Optional
By default, the
handling mode
is auto
Optional
By default,
DLDP works in
normal mode.
—
Required
If you want to
use DLDP to
detect which
fiber of the two
fibers is not
connected or
fails, you must
configure the
ports to work in
the mandatory
full duplex
mode.
Required
—