Enabling The Corresponding Aggregation Mode - H3C S7500 Series Operation Manual

Operation Manual – NAT, Netstream, Policy Routing
H3C S7500 Series Ethernet Switches
The switch supports the following five aggregation modes, each of which corresponds
to an aggregation view:
Table 2-1 Aggregation modes of Netstream
Autonomous system (AS)
aggregation
Protocol-port aggregation
Source-prefix aggregation
Destination-prefix aggregation
Source- and destination-prefix
aggregation
Depending on a selected mode, the system combines multiple stream entries of the
same type into one aggregation entry, which corresponds to one aggregation record.
The five aggregation modes are independent of each other and can be configured at
the same time.
Follow these steps to enter Netstream aggregation view:
To do...
Enter system view
Enter Netstream
aggregation view

2.2.4 Enabling the Corresponding Aggregation Mode

Perform the following configuration in Netstream aggregation view.
Follow these steps to enable the corresponding aggregation mode:
Enter system view
Enter Netstream
aggregation view
Mode
system-view
ip netstream aggregation { as |
protocol-port | destination-prefix |
prefix | source-prefix }
To do...
system-view
ip netstream
aggregation { as |
protocol-port |
destination-prefix |
prefix | source-prefix }
Classify stream entries by...
Source and destination AS numbers, outbound
interface index
Protocol number, source and destination ports
Source AS number, mask length of source
address, and source prefix
Destination AS number, mask length of destination
address, destination prefix, and outbound interface
index
Source and destination AS numbers, mask lengths
of source and destination addresses, source and
destination prefixes, and outbound interface index
Use the command...
Use the command...
2-4
Chapter 2 Netstream Configuration
Remarks
—
Required
Remarks
—
—