H3C S7500 Series Operation Manual page 314

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
To do...
Enter system view
Enter RIP view
Set the values of RIP
timers
Note:
When configuring the values of RIP timers, you should take network performance into
consideration and perform consistent configuration on all routers running RIP to avoid
unnecessary network traffic and network route oscillation.
II. Configure split horizon
Follow these steps to configure split horizon:
To do...
Enter system view
Enter interface view
Enable split horizon
Note:
Disabling the split horizon function on a point-to-point link does not take effect.
III. Configure RIP-1 packet zero field check
Follow these steps to configure RIP-1 packet zero field check:
Enter system view
Enter RIP view
Use the command...
system-view
rip
timers { update
update-timer | timeout
timeout-timer } *
Use the command...
system-view
interface
interface-type
interface-number
rip split-horizon
To do...
system-view
rip
—
—
Required
By default, Update timer value
is 30 seconds and Timeout
timer value is 180 seconds.
—
—
Required
By default, an interface uses split
horizon to send RIP packets.
Use the command...
3-10
Chapter 3 RIP Configuration
Remarks
Remarks
Remarks
—
—