H3C S7500 Series Operation Manual page 899

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Step 1: As shown in
TFTP server, and connect the switch through the Console port to the configuration PC.
Note:
You can use one PC as both the configuration device and the TFTP server.
Step 2: Run the TFTP server program on the TFTP server, and specify the path of the
program to be downloaded.
Caution:
TFTP server program is not provided with the H3C Series Ethernet Switches.
Step 3: Run the HyperTerminal program on the configuration PC. Start the switch. Then
enter the Boot Menu.
At the prompt "Enter your choice(0-5):" in the Boot Menu, press <Ctrl+U>, and then
press <Enter> to enter the Boot ROM update menu shown below:
SRPG bootrom update menu:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
Step 4: Enter 1 to in the above menu to download the Boot ROM software using TFTP.
Then set the following TFTP-related parameters as required:
Load File name
Switch IP address
Server IP address
Step 5: Press <Enter>. The system displays the following information:
Are you sure you want update SRPG bootrom?Yes or No(Y/N)
Step 6: Enter Y to start file downloading or N to return to the Bootrom update menu. If
you enter Y, the system begins to download and update the Boot ROM software. Upon
completion, the system displays the following information:
Prepare for loading...OK!
Figure 1-6, connect the switch through an Ethernet port to the
:S7500.btm
:1.1.1.2
:1.1.1.1
1-9
Chapter 1 Boot ROM and Host Software
Loading