Gvrp Configuration Examples - H3C S7500 Series Operation Manual

Operation Manual – GVRP
H3C S7500 Series Ethernet Switches
Clear GARP statistics

1.4 GVRP Configuration Examples

1.4.1 Network requirements
You need to enable GVRP on the switches to enable dynamic VLAN information
registration and update between the switches.
1.4.2 Network diagram
Switch A Switch A Switch A Switch A
Figure 1-2 Network diagram for GVRP configuration
1.4.3 Configuration procedure
Configure switch A.
# Enable GVRP globally.
<H3C> system-view
[H3C] gvrp
GVRP is enabled globally.
# Configure port Ethernet 1/0/1 to be a trunk port and to permit the packets of all the
VLANs.
[H3C] interface Ethernet1/0/1
[H3C-Ethernet1/0/1] port link-type trunk
[H3C-Ethernet1/0/1] port trunk permit vlan all
# Enable GVRP on the trunk port.
[H3C-Ethernet1/0/1] gvrp
GVRP is enabled on port Ethernet1/0/1.
Configure switch B.
# Enable GVRP globally.
<H3C> system-view
[H3C] gvrp
GVRP is enabled globally.
To do...
reset garp statistics [ interface
interface-list ]
E1/0/1 E1/ 0/2
Use the command...
Switch B Switch B Switch B Switch B
1-7
Chapter 1 GVRP Configuration
Remarks
Available in
user view.