Operation Manual – QoS
H3C S7500 Series Ethernet Switches
[H3C] interface Ethernet2/0/1
[H3C-Ethernet2/0/1] qos
[H3C-qoss-Ethernet2/0/1] traffic-red outbound ip-group 2000 64 128 20
1.11 Configuring Traffic Statistics
Refer to
1.11.1 Configuration Prerequisites
ACL rules used for traffic identifying are defined. Refer to the ACL module in the
book for defining ACL rules.
The ports that need this configuration are specified.
1.11.2 Configuration Procedure of Traffic Statistics
Follow these steps to configure traffic statistics:
Enter system view
Enter Ethernet port view
Enter QoS view
Use the ACL rules in
traffic identifying and
perform traffic statistics on
the packets matching the
ACL rules
Display the traffic
statistics
Display all the QoS
settings of the port
acl-rule: Applied ACL rules which can be the combination of various ACL rules. Type-A
LPUs' way of combination is described in
combination is described in
1.11.3 Clearing Traffic Statistics Information
Follow these steps to clear traffic statistics information:
Traffic-based Traffic Statistics
To do...
system-view
interface interface-type
interface-number
qos
traffic-statistic
{ inbound | outbound }
acl-rule [ system-index ]
traffic-statistic inbound
acl-rule [ system-index ]
display qos-interface
[ interface-type
interface-number ]
display qos-interface
[ interface-type
interface-number ] all
Table
for the introduction to traffic statistics.
Use the command...
Table
1-9, and non-type-A LPUs' way of
1-10.
1-27
Chapter 1 QoS Configuration
Remarks
—
—
—
Required
Type A LPUs support this
command.
Required
Non-type-A LPUs support
this command.
Optional
You can execute the
display command in any
view.