Configuring Ipx Routing - H3C S7500 Series Operation Manual

Operation Manual – IP Address-IP Performance-IPX
H3C S7500 Series Ethernet Switches
To do...
Configure an IPX
network number for
the VLAN interface
Note:
After the undo ipx enable command is executed, the IPX configurations are
removed and cannot be recovered using the ipx enable command.
After IPX is enabled, you must assign a network number to a VLAN interface to
enable IPX on this VLAN interface. One network number can be assigned to only
one VLAN interface.
If the IPX network number of a VLAN interface is deleted, the IPX configuration and
static routing information of this VLAN interface will be deleted at the same time.

3.2.3 Configuring IPX Routing

I. Configuring IPX static routes
Follow these steps to configure IPX static routes:
Enter system view
Enable IPX
Enter VLAN interface view
Configure an IPX network
number for the VLAN
interface
Exit VLAN interface view
Configure IPX static
routes
Use the command...
ipx network network
To do...
system-view
ipx enable
interface Vlan-interface
vlan-id
ipx network network
quit
ipx route-static network
network.node
[ preference value ] [ tick
ticks hop hops ]
Required
By default, the system does not
assign network numbers to VLAN
interfaces. That is, IPX is disabled
on all VLAN interfaces.
Use the command...
3-3
Chapter 3 IPX Configuration
Remarks
Remarks
—
Required
Disabled by default.
—
Required
By default, the system
does not assign network
numbers to VLAN
interfaces. That is, IPX is
disabled on all VLAN
interfaces.
—
Optional
The IPX static routes
whose destination
network number is
0xFFFFFFFE are default
routes.