Troubleshooting Rip Configuration - H3C S7500 Series Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
[SwitchC] rip
[SwitchC-rip] network 117.102.0.0
[SwitchC-rip] network 110.11.2.0

3.8 Troubleshooting RIP Configuration

Symptom: The switch cannot receive any RIP update when the physical connection
between the switch and the peer routing device is normal.
Solution: RIP is not enabled on the corresponding interface (for example, the undo
rip work command is executed on the interface) or RIP is not enabled by the network
command on the interface. The peer routing device is configured to work in multicast
mode (for example, the rip version 2 multicast command is executed) but the
multicast mode is not configured on the corresponding interface of the switch.
3-14
Chapter 3 RIP Configuration