H3C S7500 Series Operation Manual page 413

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
Enter system view
Enter route-policy view
Define an apply clause to
add the specified AS number
before AS path of BGP
routing information
Define an apply clause to
set the community attribute
of BGP routing information
Define an apply clause to
set the next-hop address of
routing information
Define an apply clause to
import routes into the IS-IS
area(s) at specified level(s)
Define an apply clause to
set the local preference of
BGP routing information
Define an apply clause to
set the cost of routing
information
Define an apply clause to
set the cost type of routing
information
Define an apply clause to
set the source of BGP
routing information
Define an apply clause to
set the tag field of RIP or
OSPF routing information
By default, no apply clause is defined.
Note that, when IGP routes satisfy the matching conditions specified by a route policy
and are advertised to EBGP peers, the cost defined by the apply cost-type internal
clause will be used as the cost of IGP routes. The apply cost-type internal
command is higher than the default med command but lower than the apply cost
command in terms of priority.
To do...
system-view
route-policy route-policy-name
{ permit | deny } node
node-number
apply as-path as-number-list
apply community { none | [ aa:nn ]
[ no-export-subconfed | no-export
| no-advertise ]* [ additive ] }
apply ip next-hop ip-address
apply isis [ level-1 | level-2 |
level-1-2 ]
apply local-preference
local-preference
apply cost value
apply cost-type [ internal |
external ]
apply origin { igp | egp as-number |
incomplete }
apply tag value
Chapter 7 IP Routing Policy Configuration
Use the command...
7-6
Remarks
—
—
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional