H3C S7500 Series Operation Manual page 895

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Note:
If you have chosen 9600 bps as the download baud rate, you need not modify the
HyperTerminal's baud rate, and therefore you can skip Step 4 and 5 below and
proceed to Step 6 directly. In this case, the system will not display the above
information.
Following are configurations on PC. Take the HyperTerminal using Windows operating
system as example.
Step 4: Choose [File/Properties] in HyperTerminal, click <Configure> in the pop-up
dialog box, and then select the baud rate of 115200 bps in the Console port
configuration dialog box that appears, as shown in
Figure 1-1 Properties dialog box
Chapter 1 Boot ROM and Host Software
Figure
1-5
Loading
1-1, Figure 1-2.