Error Packets Monitoring Configuration Example - H3C S7500 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Enter Ethernet interface
view
Enable error packets
monitoring

4.6.2 Error Packets Monitoring Configuration Example

I. Network requirements
Enable error packets monitoring on Ethernet 4/0/1 interface and only the packets
that are of runt type are concerned.
Set the interval for detecting error packets to 50 seconds.
II. Configuration procedure
# Enter system view.
<H3C> system-view
[H3C]
# Set the interval for detecting error packets to 50 seconds.
[H3C] qe monitor errpkt check-time 50
# Enter Ethernet interface view of Ethernet 4/0/1.
[H3C] interface Ethernet 4/0/1
[H3C-Ethernet4/0/1]
# Specify only detect current interface for error packets of runt type.
[H3C-Ethernet4/0/1] qe monitor errpkt runt
To do...
interface interface-type
interface-number
qe monitor errpkt { all |
none | runt }
Use the command...
4-10
Chapter 4 Device Management
Remarks
—
Required.
If you specify the keyword
all in the command, the
switch detects all error
packets on current
interface.
If you specify the keyword
runt, the switch only
detects error packets that
are of runt type on current
interface.
If you specify the keyword
none, the switch does not
detect the error packets
on current interface.