Enabling Multicast And Configuring Limit On The Number Of Route Entries; Configuring Suppression On The Multicast Source Port - H3C S7500 Series Operation Manual

Operation Manual – Multicast
H3C S7500 Series Ethernet Switches
4.2.1 Enabling Multicast and Configuring Limit on the Number of Route
Entries
Follow these steps to enable multicast and configure limit on the number of route
entries:
To do...
Enter system view
Enable multicast
Configure limit on
the number of
multicast route
entries
Caution:
The other multicast configurations do not take effect until multicast is enabled.

4.2.2 Configuring Suppression on the Multicast Source Port

I. Configure suppression on the multicast source port in system view
Follow these steps to configure suppression on the multicast source port in system
view:
Enter system view
Configure suppression on
the multicast source port
II. Configure suppression on the multicast source port in Ethernet port view
Follow these steps to configure suppression on the multicast source port in Ethernet
port view:
Use the command...
system-view
multicast
routing-enable
multicast route-limit
limit
To do...
system-view
multicast-source-deny
enable [ interface
interface-list ]
Chapter 4 Common Multicast Configuration
—
Required
Multicast must be enabled before
the multicast group management
protocol and the multicast routing
protocol are enabled.
Required
By default, the limit on the number of
multicast route entries is 1,024.
Use the command...
4-2
Remarks
Remarks
—
Required
Suppression on the
multicast source port is
disabled by default.