Displaying And Maintaining Basic Port Configuration - H3C S7500 Series Operation Manual

Operation Manual – Port Basic Configuration
H3C S7500 Series Ethernet Switches
Enable the hardware
speedup function outside
the port
Disable the hardware
speedup function outside
the port
Caution:
The hardspeedup enable/disable commands are applicable to type-A LPUs only,
including LS81FT48A, LS81FM24A, LS81FS24A, LS81GB8UA, and LS81GT8UA.
The speedup enable/disable commands are applicable to non-type-A LPUs only.
The commands above are diagnostic, so you cannot use them at discretion.

1.1.9 Displaying and Maintaining Basic Port Configuration

Display port configuration
information
Display the information
about port loopback
detection
Display brief information
about port configuration
Display the hybrid or trunk
ports
Display port information
about the specified unit
Clear port statistics
To do...
speedup enable
speedup disable
To do...
display interface
[ interface-type |
interface-type
interface-number ]
display
loopback-detection
display brief interface
[ interface-type
interface-number ] [ |
{ begin | include |
exclude } string ]
display port { hybrid |
trunk }
display unit unit-id
interface
reset counters interface
[ interface-type |
interface-type
interface-number ]
Use the command...
Use the command...
1-7
Chapter 1 Port Basic Configuration
Remarks
Optional
By default, the hardware
speedup function outside
the port is enabled.
Remarks
Available in any view.
Available in user view.
After 802.1x is enabled on
a port, statistics on the
port cannot be cleared by
the command.