Timer And Maximum User Number Configuration - H3C S7500 Series Operation Manual

Operation Manual – 802.1x
H3C S7500 Series Ethernet Switches
To do...
Enable 802.1x
re-authentication
Caution:
802.1x-related configurations can all be performed in system view. Port access
control mode and port access method can also be configured in port view.
If you perform a configuration in system view and do not specify the interface-list
argument, the configuration applies to all ports. Configurations performed in
Ethernet port view apply to the current Ethernet port only and the interface-list
argument is not needed in this case.
802.1x configurations take effect only after you enable 802.1x both globally and for
the specified ports.
You can enable 802.1x re-authentication on the switch either by using the dot1x
re-authenticate command or through the RADIUS server. The switch
re-authenticates the user periodically if the Termination-Action attribute value of the
Access-Accept packet sent by the authentication server to the switch is set to 1.

1.4 Timer and Maximum User Number Configuration

Table 1-2 Configure 802.1x timers and the maximum number of users
To do...
Enter system view
Configure the
maximum number
of concurrent
on-line users for
the specified ports
Use the command...
In system view:
dot1x re-authenticate [ interface
interface-list ]
In port view:
dot1x re-authenticate
Use the command...
system-view
In system view:
dot1x max-user
user-number [ interface
interface-list ]
In port view:
dot1x max-user
user-number
1-14
Chapter 1 802.1x Configuration
Remarks
Optional
Disabled by default
Remarks
—
Optional
By default, up to 1,024
concurrent on-line users are
allowed on each port.