H3C S7500 Series Operation Manual page 93

Operation Manual – Configuration File Management
H3C S7500 Series Ethernet Switches
Save the current
configuration into the Flash
Remove a specific
configuration file from the
Flash
Specify the configuration file
to be used in the next
startup
Display the primary
configuration file
Display the current
configuration
Display the configuration
performed in the current
view
Display the information
about the configuration files
used in the current and next
startups
Caution:
Currently, the extension of a configuration file is .cfg. Configuration files are saved in
the root directory of the Flash.
In the following conditions, it may be necessary for you to remove the configuration files
from the Flash:
The system software does not match the configuration file after the software of the
Ethernet switch is updated.
The configuration files in the Flash are damaged. The common reason is that
wrong configuration files are loaded.
You can save the current configuration files in one of the following two ways:
Fast saving mode: if the safely keyword is not provided, the system saves the
configuration files in the fast saving mode. In this mode, the configuration files are
saved fast. However, if restart or power-off occurs in the saving procedure, the
configuration files will be lost.
To do...
save [ file-name | safely ]
reset saved-configuration
startup saved-configuration { cfgfile
| device-name }
display saved-configuration
display current-configuration
[ [ controller | interface
[ interface-type [ interface-number ] ] |
configuration [ configuration ] ] [ |
{ begin | exclude | include } text ] ] |
[ vlan [ vlan-id ] ]
display this
display startup
Chapter 1 Configuration File Management
Use the command...
1-2
Remarks
Optional
Optional
Optional
Optional
You can
execute the
display
command
in any view.