Enabling Information Output To The Console - H3C S7500 Series Operation Manual

Operation Manual – Information Center
H3C S7500 Series Ethernet Switches
Enable information output
to a log host
Configure the source
interface through which
log information is sent to
the log host
Define an information
source
Set the format of the time
stamp
Note:
To view the debugging information of specific modules, you need to set the information
type to debug in the info-center source command, and enable debugging for
corresponding modules through the debugging command.

1.2.2 Enabling Information Output to the Console

Follow these steps to enable information output to the console:
To do...
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number | language
{ chinese | english } ]*
info-center loghost
source interface-type
interface-number
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } * { level
severity | state state } ]*
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Use the command...
1-7
Chapter 1 Information Center
Remarks
Required
By default, the switch
does not output
information to the log
host.
After you configure the
switch to output
information to the log
host, the switch uses
information channel 2 by
default.
Be sure to set the correct
IP address. A loopback IP
address will cause an
error message prompting
an invalid address.
Optional
Required
Optional