Basic Bgp Configuration; Configuring Basic Bgp Functions - H3C S7500 Series Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches

Configuring Basic BGP Functions

Configuring the
Way to
Advertise/Rece
ive Routing
Information
Configuring BGP Route Attributes
Adjusting and Optimizing a BGP Network
Configuring a
Large-Scale
BGP Network

6.3 Basic BGP Configuration

6.3.1 Configuration Prerequisites
Before performing basic BGP configuration, you need to ensure:
Network layer connectivity between adjacent nodes.
Before performing basic BGP configuration, make sure the following are available.
Local AS number and router ID
IPv4 address and AS number of the peers
Source interface of update packets.
6.3.2 Configuring Basic BGP Functions
Follow these steps to configure basic BGP functions:
Enter system view
Specify the router ID
Task
Importing Routes
Configuring BGP Route Aggregation
Enabling Default Route Advertising
Configuring the BGP Route Advertising
Policy
Configuring BGP Route Receiving Policy
Configuring BGP-IGP Route
Synchronization
Configuring BGP Route Dampening
Configuring BGP Load Balance
Configuring a BGP Peer Group
Configuring a BGP Community
Configuring BGP RR
Configuring BGP Confederation
To do...
system-view
router id router-id
Use the command...
6-7
Chapter 6 BGP Configuration
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Required
Optional
Optional
Required
Required
Optional
Optional
Remarks
—
Optional