Configuring Filtering Policies For Multicast Source/Group; Configuring Bsr/Rp - H3C S7500 Series Operation Manual

Operation Manual – Multicast
H3C S7500 Series Ethernet Switches

Configuring Filtering Policies for Multicast Source/Group

Configuring BSR/RP

Configuring PIM-SM Domain Boundary
Configuring the RP to Filter Register Messages from the DR
7.4.1 Configuring Filtering Policies for Multicast Source/Group
For the configuration of filtering policies for multicast source/group, refer to
Filtering Policies for Multicast
7.4.2 Configuring BSR/RP
Follow these steps to configure BSR/RP:
To do...
Enter system view
Enable the multicast
routing protocol
Enter PIM view
Configure candidate
BSRs
Configure candidate
RPs
Configure static RPs
Limit the range of
valid BSRs
Task
Source/Group.
Use the command...
system-view
multicast
routing-enable
pim
c-bsr interface-type
interface-number
hash-mask-len [ priority ]
c-rp interface-type
interface-number
[ group-policy
acl-number | priority
priority ]*
static-rp rp-address
[ acl-number ]
bsr-policy acl-number
7-14
Chapter 7 PIM Configuration
Remarks
Optional
Optional
Optional
Optional
Remarks
—
Required
—
Optional
By default, candidate BSRs are
not set for the switch and the
value of priority is 0.
Optional
You can configure to filter the
IP addresses
multicast groups in an ACL.
By default, candidate RPs are
not set for the switch and the
value of priority is 0.
Optional
You can configure to filter the
IP addresses
multicast groups in ACL.
By default, static RPs are not
set for the switch.
Optional
You can configure to filter the
IP addresses
multicast groups in an ACL.
By default, the range of valid
BSRs is not set for the switch.
Configuring
of some
of some
of some