H3C S7500 Series Operation Manual page 770

Operation Manual – PoE
H3C S7500 Series Ethernet Switches
Set the PoE management mode of slot 3 to auto.
Slot 3 is supplied with 400 W of power and slot 5 is supplied with full power
(namely, 806 W).
Enable PoE-compatibility detection on the PoE board in slot 3.
The input power of the AP device connected with port Ethernet 5/0/15 cannot be
greater than 9 W.
II. Networking diagram
Eth3/0/1~Eth3/0/48
IP Pone
IP Pone
IP Pone
IP Pone
Figure 1-1 Network diagram for PoE
III. Configuration procedure
# Enter system view.
<H3C>system-view
# Upgrade the PSE processing software of the PoE board in slot 5 of the S7506 switch
online.
[H3C] poe upgrade refresh 0400_001.S19
# Enable the PoE feature on the boards in slot 3 and slot 5.
[H3C] poe enable slot 3
[H3C] poe enable slot 5
# Set the PoE management mode on slot 3 to auto.
[H3C] poe power-management auto slot 3
# Set the maximum power supplied by the board in slot 3 to 400 W.
Network
S7506
Eth5 /0/1~Eth5/0 /48
AP
AP
AP
AP
1-8
Chapter 1 PoE Configuration