H3C S7500 Series Operation Manual page 901

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
PC
Figure 1-7 Local loading using FTP client
Step 1: As shown in
server, and connect the switch through the Console port to the configuration PC.
Note:
You can use one computer as both configuration device and FTP server.
Step 2: Run the FTP server program on the FTP server, configure an FTP user name
and password, and copy the program file to the specified FTP directory.
Step 3: Run the HyperTerminal program on the configuration PC. Start the switch. Then
enter the Boot Menu.
At the prompt "Enter your choice(0-5):" in the Boot Menu, press <Ctrl+U>, and then
press <Enter> to enter the Boot ROM update menu shown below:
SRPG bootrom update menu:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
Step 4: Enter 2 in the above menu to download the Boot ROM software using FTP.
Then set the following FTP-related parameters as required:
Load File name
Switch IP address
Server IP address
FTP User Name
FTP User Password
Step 5: Press <Enter>. The system displays the following information:
Are you sure you want update SRPG bootrom?Yes or No(Y/N)
Step 6: Enter Y to start file downloading or N to return to the Bootrom update menu. If
you enter Y, the system begins to download and update the program. Upon completion,
the system displays the following information:
Switch
Console port Ethernet port
FTP Client
Figure 1-7, connect the switch through an Ethernet port to the FTP
:S7500.btm
:10.1.1.2
:10.1.1.1
:7500
:abc
Chapter 1 Boot ROM and Host Software
FTP Serve r
1-11
Loading