Configuring Redirect; Configuration Prerequisites; Configuration Procedure - H3C S7500 Series Operation Manual

Operation Manual – QoS
H3C S7500 Series Ethernet Switches
[H3C-GigabitEthernet2/0/1] qos
[H3C-qosb-GigabitEthernet2/0/1] traffic-limit inbound ip-group 2000 kbps 128
exceed remark-dscp 56

1.8 Configuring Redirect

Refer to

1.8.1 Configuration Prerequisites

ACL rules used for traffic identifying are defined. Refer to the ACL module in this
manual for defining ACL rules.
The port that the packets are to be redirected to is specified.
The ports that need this configuration are specified.

1.8.2 Configuration Procedure

Follow these steps to configure redirect:
Enter system view
Enter Ethernet port
view
Enter QoS view
Configure redirect
Display the
parameters for traffic
redirect
Display all the QoS
settings of the port
acl-rule: Applied ACL rules which can be the combination of various ACL rules. The
way of combination is described in
Redirect for the introduction to redirect.
To do...
system-view
interface interface-type
interface-number
qos
traffic-redirect inbound acl-rule
[ system-index ] { cpu | interface
interface-type interface-number }
display qos-interface
[ interface-type interface-number ]
traffic-redirect
display qos-interface
[ interface-type interface-number ]
all
Use the command...
Table 1-10.
1-22
Chapter 1 QoS Configuration
Remarks
—
—
—
Required
Optional
You can execute the
display command in
any view.