H3C S7500 Series Operation Manual page 74

Operation Manual – Login
H3C S7500 Series Ethernet Switches
Launch a terminal emulation program (such as Terminal in Windows 3.X or
HyperTerminal in Windows 9X) on the PC, with the baud rate set to 9,600 bps,
data bits set to 8, parity check set to none, and flow control set to none.
Power on the switch and press Enter as prompted. The prompt (such as <H3C>)
appears.
Perform the following operations in the terminal window to assign an IP address to
the management VLAN interface of the switch.
# Enter system view
<H3C> system-view
# Enter management VLAN interface view.
[H3C] interface Vlan-interface 1
# Remove the existing IP address of the management VLAN interface.
[H3C-Vlan-interface1] undo ip address
# Set the IP address of the management VLAN interface to 202.38.160.92, with the
mask set 255.255.255.0.
[H3C-Vlan-interface1] ip address 202.38.160.92 255.255.255.0
2) Perform Telnet-related configuration on the switch. Refer to section
Configuration with Authentication Mode Being
with Authentication Mode Being
Authentication Mode Being Scheme
3) Connect your PC/terminal and the Switch to an Ethernet, as shown in
Make sure the port through which the switch is connected to the Ethernet belongs
to the management VLAN and the route between your PC and the management
VLAN interface is reachable.
Workstation
Server
Figure 3-5 Network diagram for Telnet connection establishmen
4) Launch Telnet on your PC, with the IP address of the management VLAN interface
of the switch as the parameter, as shown in
Ethernet
Configuratio n PC
Workstation
running Te lnet
3-15
Chapter 3 Logging in through Telnet
None, section
Password, and section
for more.
Ethernet port
Figure 3-6.
Telnet
Telnet Configuration
Telnet Configuration with
Figure 3-5.
t