Show Config; Common Ip Acl Commands - Dell Z9500 Reference Manual

Related

show config

Commands
show config
Display the current ACL configuration.
Z9500
Syntax
show config
Command
•
Modes
•
•
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.11.1
8.3.19.0
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.2.1.1
Example
Dell(config-ext-nacl)#show conf
!
ip access-list extended patches
Dell(config-ext-nacl)#

Common IP ACL Commands

The following commands are available within both IP ACL modes (Standard and Extended) and do not
have mode-specific options. When an ACL is created without a rule and then is applied to an interface,
ACL behavior reflects an implicit permit.
The Z9500 supports both Ingress and Egress IP ACLs.
Access Control Lists (ACL)
— displays the current ACL configuration.
CONFIGURATION-IP ACCESS LIST-STANDARD
CONFIGURATION-IP ACCESS LIST-EXTENDED
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
205