Show Config; Common Ip Acl Commands - Dell S6000 Reference Manual

show config

Display the current ACL configuration.
S6000
Syntax
show config
Command
•
Modes
•
•
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 8.3.11.1
Version
8.3.19.0
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Example
Dell(config-ext-nacl)#show conf
!
ip access-list extended patches
Dell(config-ext-nacl)#

Common IP ACL Commands

The following commands are available within both IP ACL modes (Standard and Extended) and do not
have mode-specific options. When an ACL is created without a rule and then is applied to an interface,
ACL behavior reflects an implicit permit.
The supports both Ingress and Egress IP ACLs.
Access Control Lists (ACL)
CONFIGURATION-STANDARD-ACCESS-LIST
CONFIGURATION-EXTENDED-ACCESS-LIST
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
171