Switchport Protected - Dell PowerEdge M420 Reference Manual

Syntax
storm-control unicast [level |
no storm-control unicast
• level— The configured rate as a percentage of link-speed.
rate — The configured rate in kilobits per second (kbps). (Range: 0-100)
•
Default Configuration
The default value is 5.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-1/0/1)#storm-control unicast level
5

switchport protected

Use the switchport protected command in Interface Configuration mode to
configure a protected port. The
protected ports to which this interface is assigned. You can only configure an
interface as protected in one group. You are required to remove an interface
from one group before adding it to another group.
Port protection occurs within a single switch. Protected port configuration
does not affect traffic between ports on two different switches. No traffic
forwarding is possible between two protected ports. Ports in a protected group
will not forward traffic to other ports in the group.
Syntax
switchport protected
no switchport protected
402
Ethernet Configuration Commands
rate
]
groupid
groupid
parameter identifies the set of