Pci-E Slot Priority; Perc Cards; Removing The Perc Card - Dell PowerEdge C6320 Owner's Manual

NOTE: Retain this bracket in case you need to remove the expansion card. Filler brackets must
be installed over empty expansion cards slots to maintain FCC certification of the system. The
brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside
the system.
5. Holding the card by its edges, position the card so that the card edge connector aligns with the riser
card on the riser card.
6. Insert the card edge connector firmly into the riser card until the card is fully seated.
7. Replace the screw that secures the expansion card.
8. Place the expansion card assembly into the system board assembly.
9. Install the screws that secure the expansion card assembly.
Next steps
1. Install the system board assembly.
2. Reconnect the peripherals and connect the system to the electrical outlet.
3. Turn on the system, including any attached peripherals.
Related Links
Safety instructions
Removing the system board assembly
Installing the system board assembly

PCI-E slot priority

There is no slot priority for PowerEdge C6320 as the C6320 system board has only one PCI-E Gen 3 x8
mezzanine card slot.
For the system with 1U C6320 system board assembly, only one PCI-E card can be installed in the PCI-E
Gen3 x16 slot 1.

PERC cards

Dell PowerEdge C6320 supports H330 and 12 Gbps SAS HBA cards. Dell PowerEdge C6320 also supports
H730 with processor under 105 W for thermal restrictions.

Removing the PERC card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Locate the PERC card on the system board.
2. To disconnect the storage controller cable:
98