Task 7: Enable The Ftp Server On The Router; Task 8: Identify The Files To Transfer - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide
4.
5.
6.
7.
8.

Task 7: Enable the FTP Server on the Router

The router divides its vty resources among Telnet, SSH, and FTP services. Each FTP
session requires one vty line, and the FTP service uses the authentication method
configured for the vty line. If you configured more than one vty line for Telnet access,
the FTP service uses one of those lines. If you configured only one line for Telnet
access, configure another vty line.
To enable the FTP server, use the ftp-server enable command.

Task 8: Identify the Files to Transfer

To identify all the files for the release, use a text editor to open the software release
(.rel) file on the JUNOSe software CD that you created from the downloaded,
compressed, image bundle or from the directory in which you downloaded from the
Juniper Networks website. The software release file contains a list of all the files
associated with the release. You must transfer the software release file and all the
files it contains to the user space.
130
Installing Software When a Firewall Exists
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#ip route ipNetwork networkMask ipNextHop
Press Ctrl+z to return to Privileged Exec mode.
Determine whether the router has been configured to recognize the network
host.
host1#show host
If the network host is listed, go to Step 8. Otherwise, proceed with Step 6.
Add an entry to the Static Host Table so that the router can access the network
host. Use the host command to specify the network hostname and IP address.
host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#host hostName ipAddress ftp loginname password
Press Ctrl+z to return to Privileged Exec mode.
Use the ping command to determine whether the router can now reach the
network host.
host1#ping hostname
If the router cannot reach the network host, verify that you correctly performed
the previous steps in this procedure and that the network host is operational.
host1(config)#ftp-server enable