Policy-Based Routing (Pbr); Overview - Dell S3048-ON Configuration Manual

Hide thumbs Also See for S3048-ON:

Table of Contents

Policy-based routing (PBR) allows a switch to make routing decisions based on policies applied to an interface.

When a router receives a packet, the router decides where to forward the packet based on the destination address in the packet, which is

used to look up an entry in a routing table. However, in some cases, there may be a need to forward the packet based on other criteria:

size, source, protocol type, destination, and so on. For example, a network administrator might want to forward a packet that uses

transmission control protocol (TCP) across a different next-hop than packets using Internet control message protocol (ICMP). In these

situations, you can a configure switch route packet according to a policy applied to interfaces.

In another scenario, when the packet comes from one source and wants to go to another destination, then route it to this next-hop or onto

that specific interface. This permits routing over different links or towards different networks even while the destination is the same but

depending on where the packet originates.

To enable PBR, create a redirect list. Redirect lists are defined by rules or routing policies. You can define following parameters in routing

policies or rules:

IP address of the forwarding router (next-hop IP address)

Protocol as defined in the header

Source IP address and mask

Destination IP address and mask

Policy-based Routing (PBR)

Show Quick Links

Table of Contents