Dcb-Output; Dcb-Policy Output - Dell Force10 S4810P Reference Manual

dcb-output

Create a DCB output policy to associate an ETS configuration with priority traffic.
S4810
Syntax dcb-output policy-name
To remove the ETS output policy globally, use the no dcb output policy-name
command.
Parameters
policy-name
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0
Version 8.3.16.0
Usage
Create a DCB output policy to associate a priority group with an ETS output policy with
Information
scheduling and bandwidth configuration. You can apply a DCB output policy on multiple egress
ports. When you apply an ETS output policy on an interface, ETS-configured scheduling and
bandwidth allocation take precedence over any configured settings in QoS output policies.
The ETS configuration associated with 802.1 priority traffic in a DCB output policy is used in
DCBX negotiation with ETS peers.
Related

dcb-policy output

Commands
dcb-policy output
Apply the output policy with the ETS configuration to an egress interface.
S4810
Syntax dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
policy-name
Defaults none
Command Modes INTERFACE
Command History
Version 8.3.12.0
Version 8.3.16.0
610
Enter the DCB output policy name. The maximum is 32 alphanumeric
characters.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
– applies the output policy.
Enter the output policy name.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.