Dcb-Policy Output - Dell S6000 Reference Manual

dcb-policy output

Apply the output policy with the ETS configuration to an egress interface.
S6000
Syntax
dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
policy-name
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage
Information
When you apply an ETS output policy to on interface, ETS-configured scheduling
and bandwidth allocation take precedence over any configured settings in QoS
output policies.
When you disable DCB, ETS is disabled by default. When you enable DCB, ETS is
enabled for all interfaces that have the default ETS configuration applied (all dot1p
priorities in the same group with equal bandwidth allocation).
Related dcb-output
Commands
Data Center Bridging (DCB)
Enter the output policy name.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
— creates a DCB output policy.
465