Optional) Configuring The Exported Traffic Statistics; Configuring Netstream And Setting The Packet Sampling Ratio - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
----End

7.6.4 (Optional) Configuring the Exported Traffic Statistics

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream record record-name
The record view is displayed.
Step 3 Run:
collect counter { bytes | packets }
The mode of exporting traffic statistics is configured.
Step 4 Run:
collect interface { input | output }
The traffic statistics sent to the NSC contain the indexes of the inbound interface and outbound
interface on the S9300&S9300E.
----End

7.6.5 Configuring NetStream and Setting the Packet Sampling Ratio

Context
Do as follows on the S9300&S9300E where the Flexible NetStream feature needs to be
configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ip netstream { inbound | outbound }
The NetStream function is enabled for the inbound and outbound IPv4 unicast traffic on an
interface.
Issue 01 (2012-03-15)
NOTE
The flow-label parameter is applicable to only the IPv6 traffic.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
516