Creating An Nqa Mtrace Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The MTrace test can be used in multicast troubleshooting and routine maintenance to locate the
faulty nodes and reduce configuration errors.
Pre-configuration Tasks
Before configuring the MTrace test, you must enable the multicast function in the network.
Data Preparation
To configure the MTrace test, you need the following data.
No.
1
2
3
4

6.22.2 Creating an NQA MTrace Test

This part describes how to configure an MTrace instance before performing the MTrace test for
the RPF path from the multicast source to the destination host.
Context
Do as follows on the switch that functions as the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type mtrace
The test type is set to MTrace.
Step 4 Run:
quit
Exit from the test instance view.
----End
Issue 01 (2012-03-15)
Data
Name of the test instance
IP address of the multicast source
IP address of the destination host
(Optional)VPN instance
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
330