Example For Configuring The Pwe3 Trace Test On A Single-Hop Pw - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l
6.35.23 Example for Configuring the PWE3 Trace Test on a Single-
Hop PW
Networking Requirements
As shown in
VLAN. PE-A and PE-B are connected through the MPLS backbone network. A dynamic PW
needs to be set up between PE-A and PE-B through the LSP tunnel.
The PWE3 Trace function of the single-hop PW needs to be performed to test the connectivity
of the PW between PE-A and PE-B.
Figure 6-25 Networking diagram for configuring the PWE3 Trace test on a single-hop PW
Loopback0
192.2.2.2/32
PE-A
Issue 01 (2012-03-15)
interface GigabitEthernet2/0/0
port hybrid pvid vlan 160
port hybrid untagged vlan 150
#
#
interface LoopBack0
ip address 5.5.5.9 255.255.255.255
#
ospf 1
area 0.0.0.0
network 5.5.5.9 0.0.0.0
network 40.1.1.0 0.0.0.255
#
return
Configuration file of CE-B
#
sysname CE-B
#
vlan batch 160
#
interface Vlanif160
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 160
port hybrid untagged vlan 160
#
return
Figure 6-25, CE-A and CE-B are respectively connected to PE-A and PE-B through
GE2/0/0
GE1/0/0
VLANIF120
10.1.1.1/24
VLANIF120
GE1/0/0
VLANIF110
10.1.1.2/24
GE1/0/0
VLANIF10
100.1.1.1/24
CE-A
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MPLS Backbone
Loopback0
192.4.4.4/32
GE2/0/0
VLANIF130
10.2.2.1/24
P
PW
6 NQA Configuration
Loopback0
192.3.3.3/32
GE2/0/0
VLANIF130
10.2.2.2/24
GE1/0/0
VLANIF140
PE-B
GE1/0/0
VLANIF140
CE-B
100.1.1.2/24
454