Huawei S9300 Configuration Manual page 47

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Networking Requirements
As shown in
across a public network. According to the network planning, NMS2 can manage every MIB
object except HGMP on the switch, and NMS1 does not manage the switch.
On the switch, only the modules that are enabled by default are allowed to send alarms to NMS2.
This prevents an excess of unwanted alarms from being sent to NMS2. Excessive alarms can
make faults location difficult.
Equipment administrator's contact information needs to be configured on the switch. This allows
the NMS administrator to contact the equipment administrator quickly if a fault occurs.
Figure 1-4 Networking diagram for configuring a device to communicate with an NM station
by using SNMPv1
1.1.1.1/24
1.1.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Issue 01 (2012-03-15)
Figure 1-4, two NM stations (NMS1 and NMS2) and the switch are connected
NMS1
IP Network
NMS2
Enable the SNMP agent.
Configure the switch to run SNMPv1.
Configure an ACL to allow NMS2 to manage every MIB object except HGMP on the
switch.
Configure the trap function to allow the switch to send alarms to NMS2.
Configure the equipment administrator's contact information on the switch.
Configure NMS2.
SNMP version
Community name
ACL number
IP address of the NM station
Length of the trap packet queue
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/0
VLANIF100
1.1.2.1/24
Switch
1 SNMP Configuration
32