Huawei S9300 Configuration Manual page 87

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure the Eth-Trunk between SwitchA and SwitchB.
# Configure SwitchA.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] vlan batch 100
[SwitchA] interface eth-trunk 1
[SwitchA-Eth-Trunk1] trunkport gigabitethernet 1/0/1
[SwitchA-Eth-Trunk1] trunkport gigabitethernet 1/0/2
[SwitchA-Eth-Trunk1] trunkport gigabitethernet 1/0/3
[SwitchA-Eth-Trunk1] port link-type trunk
[SwitchA-Eth-Trunk1] port trunk allow-pass vlan 100
[SwitchA-Eth-Trunk1] quit
# Configure SwitchB.
Same as the configurations on SwitchA.
Step 2 Enable global LLDP on SwitchA and SwitchB.
# Configure SwitchA.
[SwitchA] lldp enable
# Configure SwitchB.
Same as the configurations on SwitchA.
Step 3 Configure management addresses for SwitchA and SwitchB.
# Configure SwitchA.
[SwitchA] lldp management-address 10.10.10.1
# Configure SwitchB.
[SwitchB] lldp management-address 10.10.10.2
Step 4 Verify the configuration.
l View the configurations on SwitchA.
Issue 01 (2012-03-15)
Add the physical interfaces of SwitchA and SwitchB to the Eth-Trunk.
Enable global LLDP on SwitchA and SwitchB.
Configure management addresses for SwitchA and SwitchB.
Management address 10.10.10.1 for SwitchA and management address 10.10.10.2 for
SwitchB
Number of the Eth-Trunk between SwitchA and SwitchB, and numbers of the interfaces
added to the Eth-Trunk
# Check whether the physical interfaces are added to Eth-Trunk1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 LLDP Configuration
72