Example For Configuring A Mac Ping Test Instance To Detect The Connectivity Of A Vpls Network - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l
6.35.30 Example for Configuring a MAC Ping Test Instance to
Detect the Connectivity of a VPLS Network
Networking Requirements
As shown in
on a VPLS network. Three PEs on the VPLS network are enabled with CFM functions. An NQA
MAC ping test instance is configured on PE1, with the destination MAC address of trace packets
being the MAC address of the interface on PE2. The test instance is initiated from PE1 to detect
the connectivity between PE1 and PE2.
Issue 01 (2012-03-15)
#
cfm md md1
ma ma1
mep mep-id 1 interface GigabitEthernet1/0/1 outward
remote-mep mep-id 2
map vlan 10
#
nqa test-instance test macping
test-type macping
destination-address mac 00e0-fca4-8ae7
md md1 ma ma1
mep mep-id 1
#
return
Configuration file of Switch B
#
sysname SwitchB
#
cfm enable
#
interface GigabitEthernet1/0/1
undo shutdown
portswitch
port default vlan 10
#
cfm md md1
ma ma1
mep mep-id 1 interface GigabitEthernet1/0/1 outward
remote-mep mep-id 1
map vlan 10
#
return
Figure 6-32, MAC ping is enabled to detect the connectivity and locate the fault
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
480