Configuring Rmon2; Establishing The Configuration Task - Huawei S9300 Configuration Manual

Table of Contents

Advertisement

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Samples interface
Sampling interval
Last Sampling time
Latest sampled values :
octets
broadcast packets
undersize packets
fragments packets
CRC alignment errors :0
Dropped packet:
Run the display rmon prialarm command. If information about the extended alarm table is
displayed, it means that the configuration succeeds.
<Quidway> display rmon prialarm 1
Prialarm table 1 owned by Test300 is VALID.
Samples delta value
Sampling interval
Rising threshold
Falling threshold
When startup enables
This entry will exist
Latest value
Run the display rmon statistics command to display the RMON statistics.
<Quidway> display rmon statistics
Statistics entry 1 owned by Test300 is VALID.
Interface : GigabitEthernet3/0/0<ifEntry.402653698>
Received
octets
broadcast packets
undersize packets
fragments packets
CRC alignment errors:0
Dropped packet (insufficient resources):1795
Packets received according to length (octets):
64
256-511:3698

8.4 Configuring RMON2

This section describes how to configure RMON2 to monitor the traffic of a certain interface,
analyze the source and destination of data transmitted through the interface, and collect the
statistics on the data of each host that passes through the interface.

8.4.1 Establishing the Configuration Task

Before configuring RMON2, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
By configuring RMON2, you can monitor the traffic on an Ethernet interface that connects to
the network, analyze the hosts the data on the interface comes from and goes to, and collect
statistics of the data passing through the interface from each host on the network.
Pre-configuration Tasks
Before configuring RMON2, configure parameters for Ethernet interface.
Issue 01 (2012-03-15)
: GigabitEthernet3/0/0<ifEntry.402653698>
: 30(sec) with 10 buckets max
: 0days 00h:09m:43s
:645
:7
:6
:0
:0
: .1.3.6.1.2.1.16.1.1.1.6.1+.1.3.6.1.2.1.16.1.1.1.7.1
: 30(sec)
: 1000(linked with event 2)
: 0(linked with event 2)
: risingOrFallingAlarm
: forever
: 16
:
:142915224 , packets
:11603
:0
:0
:150183
,
65-127
,
512-1023:0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
, packets
, multicast packets :0
, oversize packets
, jabbers packets
, collisions
, utilization
, multicast packets:756252
, oversize packets :0
, jabbers packets
, collisions
:150183
,
128-255
,
1024-1518:0
8 RMON and RMON2 Configuration
:7
:0
:0
:0
:0
:1749151
:0
:0
:1383
542

Advertisement

Table of Contents
loading

This manual is also suitable for:

S9300e

Table of Contents