Nqa Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
About This Chapter
This chapter describes how to configure the Network Quality Analysis (NQA) to monitor the
network operating status and collect network operation indexes in real time.
Context
The NQA function of the S9300&S9300E is controlled by the license.
Generally, the NQA commands can be run on a new S9300&S9300E, but the NQA function cannot take effect.
To make the NQA function of an S9300&S9300E effective, contact the Huawei regional office to buy the license.
6.1 Introduction to NQA
This section helps you understand the background and functions of Network Quality Analysis
(NQA).
6.2 Comparisons Between NQA and Ping
This part describes the differences between NQA and Ping tests.
6.3 NQA Server and NQA Clients
This part describes the relationships between NQA client, NQA server, and NQA test instance.
6.4 NQA Supported by the S9300&S9300E
This part describes NQA test types and scheduling modes supported by the S9300&S9300E.
6.5 Configuring the ICMP Test
This section describes how to configure an Internet Control Message Protocol (ICMP) test to
check the IP network connectivity.
6.6 Configuring the FTP Download Test
This section describes how to configure a File Transfer Protocol (FTP) download test to check
the FTP download performance.
6.7 Configuring the FTP Upload Test
This section describes how to configure an FTP upload test to check the FTP upload performance.
6.8 Configuring the HTTP Test
This section describes how to configure a Hypertext Transfer Protocol (HTTP) test to check the
responding speed of the HTTP service in each phase.
Issue 01 (2012-03-15)
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6

NQA Configuration

6 NQA Configuration
257